DWEII 2 Pack USB Step Down Converter DC-DC Buck Module 9V- 35V 12V 24V to 5V 3A QC 3.0 Charging Module Waterproof Power Regulator Car
Asin: B09VC3VS18 | Ean: 0701715515437 | UPC: 701715515437
As an Amazon Associate we earn a fee from qualifying purchases when you follow a link to Amazon from this page. We rank the products, but the links to Amazon are promotional.❃❃Commonly Used In Led Light, Gps Navigation Device, Car Recorder, Displayer, Mp3, Mp4, Cell Phone And Etc..
❃❃With Usb Type-A Female Socket Charging Cable, Widely Used In Cars, Motorcycles And Rvs.
❃❃Note: No Identification Resistor, Can Not Be Used For Some Devices. Application: Use For Charging Cell Phone, Power For Electronic Device Etc..
❃❃Our 12V/24V To 5V Step Down Converters Can Be Highly Efficient (Higher Than 90%).
❃❃Convert Unstable Voltage Dc 12V To Stable Dc 5V/3A 15W Output.
Features
- Epoxy resin potting, shockproof, waterproof, moisture-proof, dust-proof, long-term stable and reliable quality. Overvoltage, overcurrent, overheating, and short circuit can be automatically protected and resume normal operation.
- Convert unstable voltage DC 12V to stable DC 5V/3A 15W output
- Commonly used in LED light, GPS navigation device, car recorder, displayer, MP3, MP4, cell phone and etc.
- Our 12v/24v to 5v step down converters can be highly efficient (higher than 90%)
- With USB Type-A female socket charging cable, widely used in cars, motorcycles and RVs
- Note: No identification resistor, can not be used for some devices. Application: Use for charging cell phone, power for electronic device etc.
- See more on Amazon...
Brand: DWEII | Manufacturer: DWEII
See On Amazon Similar To DWEII 2 Pack USB Step
#1
DWEII 10PCS Type-C USB 5V 2A Boost Converter Step-Up Power Module Lithium Battery Charging Protection Board LED Display USB for DIY Charger (no Welding Version)
Asin: B09YD5C9QC | Ean: 0701715515956 | UPC: 701715515956
❃❃It Supports The External Key, Which Is Connected To The K Point And The Output Negative Pole. Short Press To Turn On The Power Display And Turn On The 5V Output. Two Consecutive Short Presses Will Turn Off The Power Display And Turn Off The 5V Output..
❃❃1; When The Charging Current Drops To 100Ma After Reaching The Final Floating Charging Voltage, The Charging Cycle Will Be Automatically Terminated; 2; When The Battery Voltage Drops Below 4.1V, The Charging Cycle Starts Again. 3; When The Battery Voltage Is Lower Than 2.8V, The Battery Will Be Pre Charged With A Current Of 180Ma..
❃❃When The Load Current Is Less Than 50Ma Continuously, The Output Will Be Turned Off..
❃❃Usb Is No Welding Version.
Features
- 10PCS ( no welding version) Type-C USB 5V 2A Boost Converter Step-Up Power Module Lithium Battery Charging Protection Board LED Display USB For DIY Charger
- USB is no welding version
- It supports the external key, which is connected to the K point and the output negative pole. Short press to turn on the power display and turn on the 5V output. Two consecutive short presses will turn off the power display and turn off the 5V output.
- When the load current is less than 50mA continuously, the output will be turned off.
- 1; When the charging current drops to 100mA after reaching the final floating charging voltage, the charging cycle will be automatically terminated; 2; When the battery voltage drops below 4.1V, the charging cycle starts again. 3; When the battery voltage is lower than 2.8V, the battery will be pre charged with a current of 180mA.
- See more on Amazon...
Brand: DWEII | Manufacturer: DWEII
See On Amazon #2
DWEII 10-Pack Type-C QC AFC PD2.0 PD3.0 to DC Spoof Scam Fast Charge Trigger Polling Detector USB-PD Notebook Power Supply Change Board Module
Asin: B0CGVD7B83 | Ean: 0687117729897 | UPC: 687117729897
❃❃ Fast Charging Protocols:Pd2.0/Pd3.0, Qc2.0/Qc3.0, And Afc.
❃❃ You Will Get 10Pcs Type-C Qc Afc Pd2.0 Pd3.0 To Dc Spoof Scam Fast Charge Trigger Polling Detector Usb-Pd Notebook Power Supply Change Board Module.
❃❃ Voltage Regulation: According To The Table On The Back Of The Board, Adjust The Dip Switch To Control The Voltage Output.
❃❃ Voltage: 5V, 9V, 12V, 15V, 20V (Voltage Step Is Not Supported); ❃❃Note(Important): 1. Since There Is No Voltage Indicator After Adjusting The Dip Switch, Use A Multimeter To Measure The Voltage Before Connecting To The Appl Ication Circuit. 2. If The Dip Switch Is Not Adjusted According To The Table, The Module Will Output Any Voltage Of The Above Voltage..
Features
- 10PCS Type-C QC AFC PD2.0 PD3.0 to DC Spoof Scam Fast Charge Trigger Polling Detector USB-PD Notebook Power Supply Change Board Module
- Voltage: 5V, 9V, 12V, 15V, 20V (voltage step is not supported) Note(important): 1. Since there is no voltage indicator after adjusting the dip switch, use a multimeter to measure the voltage before connecting to the appl ication circuit. 2. If the dip switch is not adjusted according to the table, the module will output any voltage of the above voltage.
- Fast charging protocols:PD2.0/PD3.0, QC2.0/QC3.0, and AFC
- Voltage regulation: According to the table on the back of the board, adjust the dip switch to control the voltage output
- you will get 10pcs Type-C QC AFC PD2.0 PD3.0 to DC Spoof Scam Fast Charge Trigger Polling Detector USB-PD Notebook Power Supply Change Board Module
- See more on Amazon...
Brand: DWEII | Manufacturer: DWEII
See On Amazon #3
3pcs Type C BMS 2S 3S 4S 1A 2A 4A 18650 Lithium Battery Charger Board USB C Step-up Boost Module for Li-Po Polymer Power Bank(3pcs 3S 4A)
Asin: B0BZC7TWC7 | Ean: 0701715520806 | UPC: 701715520806
Protection For Battery Voltage Being Low Than Input And Short Battery Good Adaptability To Input Supply With Limited Driving Capability.
Led Indicator : ''Cr'' Led Is Charge Status Indicator ''Ok'' Led Is Fully Charged Or Constant Voltage Mode;.
Size :39Mm X 18Mm X 6.3Mm;Weight : 5G; Battery Overvoltage Protection.
Input Type-C 5V; Operating Temperature-40℃ To +85℃;.
Features
- 3PCS Multi-Cell 2S 3S 4S Type-C to 8.4V 12.6V 16.8V Step-Up Boost LiPo Polymer Li-Ion Charger 7.4V 11.1V 14.8V 18650 Lithium Battery (3S-4A)
- Input Type-C 5V; Operating Temperature 40 to 85 ;
- Protection for Battery Voltage Being Low than Input and Short Battery Good adaptability to Input Supply with Limited Driving Capability
- Size :39mm x 18mm x 6.3mm;Weight : 5g; Battery Overvoltage Protection
- Led indicator : ''CR'' LED is charge status indicator ''OK'' LED is fully charged OR Constant voltage mode;
- See more on Amazon...
Brand: Dweii | Manufacturer: Dweii
Weight: 0.01 Pounds
See On Amazon #4
DWEII 1PCS 60W 6-35V DC to USB Type C PD 3.0 QC4+ & Type A QC3.0 DC Fast Charge 12V 24V Step-Down Power Module
Asin: B0C5J7VZTK | Ean: 0701715520998 | UPC: 701715520998
This Product Has A Small Size (50*17*12Mm), Which Is Suitable For Users To Diy. If It Is Combined With A 12-Volt Power Adapter, It Can Be Used For Daily Quick Charging And Storage At The Same Time Batteries, Solar Panels, Dc Generators And Other Power Supply!Outdoor/Car/Power Failure And Other Occasions Under The Good Helper!.
1Pcs 60W 6-35V Dc To Usb Type C Pd 3.0 Qc4+ & Type A Qc3.0 Dc Fast Charge 12V 24V Step-Down Power Module.
Supports All Major Fast Charge Protocols: Usb Pd 3.0 (Pps) Qc4+ Qc4.0 Qc3.0 Qc2.0.
Input Must Be 1V Higher Than The Output Size: 50X17x12mm Sw3516 Ic ; Blue Led Power Indicator Red Led Fast Charge Indicator ;.
Features
- Input: 6-35V DC Output: USB-C or USB-A, 60W 3-20V DC (adjusts automatically according to the fast charge protocol)
- Input must be 1V higher than the output Size: 50x17x12mm SW3516 IC ; Blue LED Power Indicator Red LED Fast Charge Indicator
- This product has a small size (50*17*12mm), which is suitable for users to DIY. If it is combined with a 12-volt power adapter, it can be used for daily quick charging and storage at the same time Batteries, solar panels, dc generators and other power supply!Outdoor/car/power failure and other occasions under the good helper!
- Supports all major fast charge protocols: USB PD 3.0 (PPS) QC4+ QC4.0 QC3.0 QC2.0
- 1PCS 60W 6-35V DC to USB Type C PD 3.0 QC4+ & Type A QC3.0 DC Fast Charge 12V 24V Step-Down Power Module
- See more on Amazon...
Brand: DWEII | Manufacturer: DWEII
See On Amazon #5
DWEII Mach3 USB Interface Board, USB MACH3 100Khz Motion Controller Card Breakout Board Interface Breakout Board for CNC Engraving, Servo Motor, Stepper Motor Servo Motor
Asin: B0B24Q7DKW | Ean: 0701715516335 | UPC: 701715516335
❃❃The 4 General-Purpose Isolated Relay Drive Output Interface Can Drive Four Relays For Controlling The Spindle Starts, Forward Rotating And Reverse Rotating, Pumps And Other Device.
❃❃Usb Interface Board Supports For 4-Axis Linkage, You Can Connect Four Stepper Motor Drives Or Servo Drives. 4 General-Purpose Inputs, You Can Connect The Limit Switch, Estop Switch, Probe Switch, Back To Zero And Other Device;.
❃❃Support For Limit Switch: Support For Limit Switch .Support For Connecting Electronic Handwheel .4 General-Purpose Inputs, You Can Connect The Limit Switch, Estop Switch, Probe Switch, Back To Zero And Other Device.
❃❃Maximum Step-Pulse Frequency Is 100Khz, Which Is Suitable For The Servo Or Stepping Motor.
Features
- Super USB interface Mach3 motion control card, free drive, simple configuration and good compatibility. Especially designed for notebook and tablet PC
- Maximum step-pulse frequency is 100KHz, which is suitable for the servo or stepping motor
- The 4 general-purpose isolated relay drive output interface can drive four relays for controlling the spindle starts, forward rotating and reverse rotating, pumps and other device
- Support for Limit Switch: Support for limit switch .Support for connecting electronic handwheel .4 general-purpose inputs, you can connect the limit switch, estop switch, probe switch, back to zero and other device
- Usb interface board supports for 4-axis linkage, you can connect four stepper motor drives or servo drives. 4 general-purpose inputs, you can connect the limit switch, estop switch, probe switch, back to zero and other device
- See more on Amazon...
Brand: DWEII | Manufacturer: DWEII
See On Amazon
Looking For Something Else?
Search